HVAC replacement cost by size
Find your size in the table. In New Hampshire the range runs from $5,830-$9,370 for 1.5 tons to $12,870-$21,950 for 5 tons; a quote that does not state the measured size is hard to compare.
| Size | Cost |
|---|---|
| 1.5 tons | $5,830-$9,370 |
| 2 tons | $6,830-$11,170 |
| 2.5 tons | $7,840-$12,970 |
| 3 tonsMost common | $8,840-$14,760 |
| 3.5 tons | $9,850-$16,560 |
| 4 tons | $10,850-$18,350 |
| 5 tons | $12,870-$21,950 |
HVAC replacement cost by material or type
The gap between options is wide: dual-fuel (heat pump + gas furnace) costs about 1.1 times as much as central AC + gas furnace (split system) in New Hampshire, and ductless mini-split, single zone trims about 63%.
What will your New Hampshire HVAC system cost?
We have already loaded New Hampshire prices for this HVAC replacement estimate. Enter your project details and ZIP code for a free planning estimate.
Pick your city
| City | Typical job | Link |
|---|---|---|
| Manchester | $8,810-$14,720 | Manchester |
| Nashua | $8,810-$14,720 | Nashua |
State conditions
Local planning note for New Hampshire
Comparing New Hampshire's cities beyond the price
BLS reports one wage figure for HVAC technicians across Manchester and Nashua, 20% above the U.S. median, so labor does not explain HVAC price gaps between them. FEMA rates heat-wave risk Relatively Low in every covered New Hampshire county.
Measured against home values, the same job weighs most in Manchester (3.2% of the median home) and least in Nashua (2.9%).
| City | Pay for HVAC technicians vs U.S. | HVAC permit ($12,000 job) | FEMA heat-wave risk (county) | Typical job as share of median home value |
|---|---|---|---|---|
| Manchester | +20% | Not published | Relatively Low | 3.2% |
| Nashua | +20% | Not published | Relatively Low | 2.9% |
Pay: BLS May 2025 metro median for the trade vs the U.S. median. Permit: base fee from the city's own schedule, before surcharges; "Not published" means no priceable figure was found online.
Local planning note for New Hampshire
Sales tax on an HVAC replacement in New Hampshire
New Hampshire has no general sales tax. Expect an HVAC replacement quote to be the full price, with no state tax added.
Labor rates
On an HVAC replacement job in New Hampshire, HVAC technicians earn a median $35.51 an hour. After insurance, payroll taxes and overhead, contractors bill about $71-$92 per worker-hour.
Before you sign in New Hampshire
Get every quote to include
- equipment model, capacity, efficiency, and documented load calculation
- ductwork, electrical, condensate, venting, and controls
- removal, startup, commissioning, and homeowner instructions
- who checks and documents any required permits or inspections
Local planning note for New Hampshire
Protecting your New Hampshire home from contractor liens
Anyone who works on an HVAC replacement or supplies material for it, and isn't paid, may be able to file a mechanic's lien against the house. In New Hampshire, a sub or supplier without a contract with you must give you notice before furnishing work, and a later notice covers only amounts then due (RSA 447:5-6).
After a notice, the contractor must give you written accounts every 30 days and you must hold back enough to cover the claim (447:8). A lien expires after 120 days unless secured by a court attachment. With an HVAC replacement, the supply house that sold the condenser and air handler is the lien claimant to watch for.
Frequently Asked Questions
What does HVAC replacement cost in New Hampshire?
They are planning estimates, not contractor bids.
Does pay for HVAC technicians vary across New Hampshire?
Not much. Across the 2 New Hampshire cities we cover, pay for HVAC technicians stays within a few points, from 20% above the national median in Manchester to 20% above in Manchester (BLS, May 2025).
Do HVAC contractors need a license in New Hampshire?
Yes. In New Hampshire: gas fitter license for gas work; no HVAC license. Look the contractor up with the Local building department before you sign.
Should I get a heat pump instead of AC in New Hampshire?
It's worth pricing.
Which refrigerant should a new AC use?
Newer systems use R-454B or R-32 because EPA rules phased out R-410A in new home AC units from 2025. Ask which one each quote uses.
Ready for your own number?
We have already loaded New Hampshire prices for this HVAC replacement estimate. Enter your project details and ZIP code for a free planning estimate.
Sources and methodology
- NumeralQ estimator (pricing as of 2026-10-26)
- Fixr cost guide, retrieved 2026-10-26
- Home Depot online prices, store 121, retrieved 2026-10-26
- This Old House cost guide, retrieved 2026-10-26
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 (https://www.bls.gov/oes/)
- City permit fee schedules, retrieved October 2026 (see the permit line for this page's source)
- NumeralQ pricing model v2: materials plus local labor, methodology at /methodology
- NH utilities, checked 2026-10-26 (https://www.nhsaves.com/)
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025, metro-area median pay by trade compared with the U.S. median (https://www.bls.gov/oes/tables.htm)
- FEMA National Risk Index, county risk ratings (https://hazards.fema.gov/nri/)
- U.S. Census Bureau, American Community Survey 2020–2024 5-year estimates, place-level tables B25018 (median rooms), B25035 (median year built), B25077 (median home value), B25024 (units in structure), B25003 (owner and renter occupancy) and B25041 (bedrooms) (https://data.census.gov/)
- NumeralQ pricing model v2: typical-job midpoints for all 147 markets, compared with the Census median home value (methodology at /methodology)
- New Hampshire Department of Revenue Administration, checked November 10, 2026 (https://www.revenue.nh.gov/)
- Levelset, New Hampshire lien law FAQs (statute sections as cited there), checked November 10, 2026 (https://www.levelset.com/mechanics-lien/new-hampshire-lien-law-faqs/)
Installed: Central AC + gas furnace (split system)