Furnace Replacement Cost in Gulfport, MS: 2026 Local Guide

Typical Gulfport job · 80,000 BTU furnace
$4,570-$7,7308% below U.S.

Plan on $4,570-$7,730 for an 80,000 BTU furnace in Gulfport, 8% below the national typical job.

For comparable written proposals, confirm fuel type and equipment capacity, venting and combustion-air scope, duct connections, and startup commissioning.

Your options

Budget
Electric furnace
$2,880-$5,200
Most common
Gas furnace, 95-96% AFUE
$4,570-$7,730
Premium
Gas boiler, hot water (high efficiency)
$7,050-$11,200
  • Local labor and material prices
  • 147 U.S. markets
  • Free, no sign-up to see your range
Cost by size

Furnace replacement cost by size

Size moves the price more than anything else. In Gulfport, going from 40,000 BTU to 120,000 BTU takes the job from $4,130-$6,850 to $5,000-$8,600, so have the size measured before comparing quotes.

SizeCost
40,000 BTU$4,130-$6,850
60,000 BTU$4,350-$7,290
80,000 BTUMost common$4,570-$7,730
100,000 BTU$4,780-$8,160
120,000 BTU$5,000-$8,600

Installed: Gas furnace, 95-96% AFUE

Cost by material

Furnace replacement cost by material or type

In Gulfport, electric furnace comes in about 34% under gas furnace, 95-96% AFUE, and gas boiler, hot water (high efficiency) runs roughly 1.5 times the price, so get each option you are weighing priced on the same quote (gas furnace, 95-96% AFUE here: $4,570-$7,730).

TypeTypical job
Electric furnace$2,880-$5,200
Gas furnace, 80% AFUE (single stage)$3,840-$6,170
Gas furnace, 95-96% AFUEMost common$4,570-$7,730
Propane furnace (95%)$4,930-$8,200
Oil furnace$5,970-$9,660
Gas furnace, 96%+ 2-stage or modulating$6,190-$9,510
Gas boiler, hot water (high efficiency)$7,050-$11,200

Materials include waste and contractor markup. 80,000 BTU furnace

What will your Gulfport furnace cost?

We have already loaded Gulfport prices for this furnace replacement estimate. Enter your project details and ZIP code for a free planning estimate.

Get my estimate
Project extras

Add-ons and extra work

These 5 extras are where quotes most often grow. The largest single line in Gulfport is "Ductwork repairs" at $2,020-$2,900 for the job, so ask whether it is included.

  • New PVC venting (when going 80% to 95%)$358-$942 / job
  • Gas line work$297-$875 / job
  • Ductwork repairs$2,020-$2,900 / job
  • Variable-speed blower upgrade$460-$1,100 / job
  • Smart thermostat$241-$463 / each
Show material-only prices
Add-onMaterials
New PVC venting (when going 80% to 95%)$173-$460 / job
Gas line work$115-$402 / job
Ductwork repairs$230-$575 / job
Variable-speed blower upgrade$460-$1,040 / job
Smart thermostat$132-$322 / each

Installed price per unit

Local conditions

What makes Gulfport different for this job

Gulfport homes and the local housing stock

What Gulfport's housing says about furnace work

Census figures put the median construction year at 1986 in Gulfport and 1976 for the median of NumeralQ's 147 markets, and house age shapes most furnace swaps here.

Set against the $174,600 median home value, the typical furnace replacement in Gulfport comes to roughly 3.5%. Only 18 of 147 markets come out higher, so it is a bigger decision relative to the house than in most cities.

In Gulfport, where 55% of homes are owner-occupied and 68% of units are houses, the choice on a furnace replacement is usually the owner's. Ask for a room-by-room load calculation (ACCA Manual J), which the residential code requires for sizing.

When to plan this work in Gulfport

Timing a furnace replacement in Gulfport

The mildest months in Gulfport are March and April, when NOAA's normals show the least heating and cooling demand at the Gulfport - Biloxi Airport weather station. Planning a furnace replacement for then means a day without heat or air conditioning is no hardship, unlike in January.

January is the heaviest heating month in Gulfport, with about 416 heating degree days at the Gulfport - Biloxi Airport weather station, so an old furnace is most likely to fail then.

Local rules and records for Gulfport

Rebates from your utility

Program pages from the utility. Amounts change often, so check the program page.

How hard Gulfport winters run

Gulfport averages 1,507 heating degree days a year, according to NOAA's 1991–2020 normals, against 2,511 at the median Mississippi station and 5,483 at the median U.S. station. The higher the number, the more a furnace runs.

Piped gas is the main heat in 25% of Gulfport homes, per Census data, against 46% nationally.

Mississippi's average residential gas price was $16.65 per Mcf in 2025 (EIA), against $15.34 nationally. Local utility rates vary.

The federal floor for a new gas furnace is 80% AFUE. A 90%-plus condensing furnace needs plastic venting and a drain, so ask whether the quote includes that work.

Heating in Gulfport at a glance
Heating degree days1,507
Nights at or below 32°F16
Gas price, Mississippi 2025$16.65 per Mcf (U.S. $15.34)
Federal furnace minimum80% AFUE (non-weatherized gas)
HVAC license (Mississippi)Residential HVAC license
Where to check a licenseMississippi State Board of Contractors

Local data checked October 2026 · Sources at the bottom of the page

Flood rules for HVAC and repairs in Gulfport

For properties in a Gulfport special flood hazard area, the flood ordinance requires heating, air conditioning, electrical, plumbing and other service equipment to be designed or located to keep out floodwater and placed at least 1 foot above the base flood elevation. Improvements over any 10-year period that together reach 50 percent of the structure's pre-improvement market value are a substantial improvement, which brings new-construction standards, including elevating the lowest floor.

Ask the floodplain administrator whether the 1-foot rule is applied to a like-for-like equipment swap.

Gulfport Code Appendix B, Flood Damage Prevention (Ord. 2929), Art. 2 and Art. 5 Sec. A · Checked October 10, 2026

Local risks for this work in Gulfport

Local risks that change the job in Gulfport

Gulfport sits in Harrison County, which carries a Relatively High rating for coastal flooding risk in FEMA's National Risk Index. If the house is in a mapped flood hazard area, a new furnace has to sit at or above the design flood elevation under the residential code, which can mean moving it out of a basement. Check FEMA's flood map for your address.

Nearby pricing

How Gulfport compares with nearby cities

Labor

Labor rates

On a furnace replacement job in Gulfport, HVAC technicians earn a median $23.19 an hour. After insurance, payroll taxes and overhead, contractors bill about $46-$60 per worker-hour.

HVAC technicians

$23.19/hrMedian pay
$46-$60/hrBilled rate

Median pay: BLS May 2025. Billed rate: what a contractor charges per worker-hour, estimated at 2.0 to 2.6 times pay (insurance, payroll taxes, overhead, profit).

Before you sign

Before you sign in Gulfport

Get every quote to include

  • fuel type, equipment model, capacity, and documented sizing basis
  • venting, combustion air, gas or electrical connections, and ductwork
  • removal, startup, commissioning, and safety checks included
  • who checks and documents any required permits or inspections

Contractors per home in Gulfport

How many HVAC shops work in Gulfport's area

If you need a furnace replacement, Harrison County, which includes Gulfport, had 49 plumbing, heating and air conditioning contractors in 2023, according to the Census Bureau. That's 5.2 for every 10,000 homes, 33% below the U.S. rate of 7.7, and the 28th lowest of the 135 counties NumeralQ prices. That count includes plumbers, since the Census groups them with HVAC firms.

Businesses are counted where they're based, and many serve several counties, so a low count doesn't mean no one will come to Gulfport. It does mean less room to bargain on a furnace replacement.

HVAC permits and contractor licenses in Gulfport

In Gulfport, any owner, agent or contractor who will install, alter, repair, convert or replace a mechanical system must first get a permit from the building official, and the city's air conditioning inspector inspects the work. The city also issues an air conditioning and heating contractor's license that requires five years' experience, manufacturer-approved installer status and an exam, or a mechanical engineering degree.

Whether homeowners may do their own HVAC work was not established; ask the city.

Gulfport Code Ch. 3, Art. IV (mechanical installations, Secs. 3-146 to 3-153) · Checked October 10, 2026

Common questions

Frequently Asked Questions

How much does Furnace Replacement cost in Gulfport, MS?

Furnace replacement cost in Gulfport, MS: $4,570-$7,730 (80,000 BTU furnace). The table above breaks it out by option.

How does pay for HVAC technicians in the Gulfport-Biloxi area compare with the national median?

Median pay for HVAC technicians in the Gulfport-Biloxi, MS metro area is 21% below the national median, according to BLS data for May 2025. Pay is one input to a quote, not the price itself.

What climate zone is Gulfport in?

Harrison County is in climate zone 2A on the DOE's county list, which energy codes use to set insulation and window levels.

Are federal home energy rebates available in Mississippi?

Mississippi's federal home electrification rebate program hasn't launched yet, according to NASEO's September 2026 status list.

Ready for your own number?

We have already loaded Gulfport prices for this furnace replacement estimate. Enter your project details and ZIP code for a free planning estimate.

Get my estimate
Illustrative payment estimates NumeralQ examples use fixed assumptions. They are not loan offers or pre-qualification; NumeralQ does not contact lenders or access credit reports. View payment assumptions

Sources and methodology

We start from a national baseline and adjust it for Gulfport (0.87×). How we estimate

$4,570-$7,730NumeralQ planning estimate
Get my estimate