Furnace replacement cost by size
Find your size in the table. In Iowa the range runs from $4,610-$7,480 for 40,000 BTU to $5,480-$9,230 for 120,000 BTU; a quote that does not state the measured size is hard to compare.
| Size | Cost |
|---|---|
| 40,000 BTU | $4,610-$7,480 |
| 60,000 BTU | $4,830-$7,920 |
| 80,000 BTUMost common | $5,050-$8,350 |
| 100,000 BTU | $5,270-$8,790 |
| 120,000 BTU | $5,480-$9,230 |
Furnace replacement cost by material or type
The gap between options is wide: gas boiler, hot water (high efficiency) costs about 1.4 times as much as gas furnace, 95-96% AFUE in Iowa, and electric furnace trims about 32%.
What will your Iowa furnace cost?
We have already loaded Iowa prices for this furnace replacement estimate. Enter your project details and ZIP code for a free planning estimate.
Pick your city
| City | Typical job | Link |
|---|---|---|
| Cedar Rapids | $5,050-$8,350 | Cedar Rapids |
| Des Moines | $5,120-$8,450 | Des Moines |
State conditions
Local planning note for Iowa
Iowa city by city: what actually changes
For furnace replacements, pay for HVAC technicians ranges from 0% below the U.S. median in Cedar Rapids to 3% above the U.S. median in Des Moines, a 3-point gap that shows up most in labor-heavy bids. Gas heat is most common in Cedar Rapids, where 77% of homes use it, and least common in Des Moines (64%), so an all-electric quote is a bigger switch in Cedar Rapids.
Against home values, a typical furnace job is about the same everywhere in Iowa we cover, 3.5% to 3.6% of the median home.
| City | Pay for HVAC technicians vs U.S. | HVAC permit ($12,000 job) | Homes heating with gas | Typical job as share of median home value |
|---|---|---|---|---|
| Cedar Rapids | 0% | Not published | 77% | 3.6% |
| Des Moines | +3% | Not published | 64% | 3.5% |
Pay: BLS May 2025 metro median for the trade vs the U.S. median. Permit: base fee from the city's own schedule, before surcharges; "Not published" means no priceable figure was found online.
Labor rates
On a furnace replacement job in Iowa, HVAC technicians earn a median $29.17 an hour, 1% below the U.S. median. After insurance, payroll taxes and overhead, contractors bill about $58-$76 per worker-hour.
Before you sign in Iowa
Get every quote to include
- fuel type, equipment model, capacity, and documented sizing basis
- venting, combustion air, gas or electrical connections, and ductwork
- removal, startup, commissioning, and safety checks included
- who checks and documents any required permits or inspections
Local planning note for Iowa
Protecting your Iowa home from contractor liens
Anyone who works on a furnace replacement or supplies material for it, and isn't paid, may be able to file a mechanic's lien against the house. Iowa runs an online Mechanics' Notice and Lien Registry. The contractor posts the job and gives you notice, and subs post their preliminary notices there (Iowa Code 572.13A, 572.13B).
Search the registry before every payment. On a residential job, a sub's lien is limited to what you owed the contractor when you got that sub's notice (572.13B(3)). On a furnace replacement, the HVAC distributor that sold the furnace to your contractor is the usual lien claimant, so ask whether the equipment has been paid for.
Frequently Asked Questions
What does furnace replacement cost in Iowa?
They are planning estimates, not contractor bids.
Does pay for HVAC technicians vary across Iowa?
Not much. Across the 2 Iowa cities we cover, pay for HVAC technicians stays within a few points, from 1% below the national median in Cedar Rapids to 3% above in Des Moines (BLS, May 2025).
Who licenses furnace installers in Iowa?
Iowa's rule is state mechanical (HVAC) license. The Iowa DIAL has a free license lookup.
Would a heat pump cost less to run than a gas furnace in Iowa?
Furnace replacement cost in Iowa: $5,050-$8,350 (80,000 BTU furnace).
What is the minimum furnace efficiency allowed?
80% AFUE for a standard indoor gas furnace under current DOE rules.
Ready for your own number?
We have already loaded Iowa prices for this furnace replacement estimate. Enter your project details and ZIP code for a free planning estimate.
Sources and methodology
- NumeralQ estimator (pricing as of 2026-10-26)
- Fixr cost guide, retrieved 2026-10-26
- Home Depot online prices, store 121, retrieved 2026-10-26
- NumeralQ estimate (no single published range; set from material prices and typical install hours)
- This Old House cost guide, retrieved 2026-10-26
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 (https://www.bls.gov/oes/)
- City permit fee schedules, retrieved October 2026 (see the permit line for this page's source)
- NumeralQ pricing model v2: materials plus local labor, methodology at /methodology
- Alliant Energy, checked 2026-10-26 (https://www.alliantenergy.com/ways-to-save/instant-discounts/iowa)
- MidAmerican Energy, checked 2026-10-26 (https://www.midamericanenergy.com/home-discounts-and-rebates)
- U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025, metro-area median pay by trade compared with the U.S. median (https://www.bls.gov/oes/tables.htm)
- U.S. Census Bureau, American Community Survey 2020–2024 5-year estimates, table B25040 (house heating fuel) (https://data.census.gov/)
- U.S. Census Bureau, American Community Survey 2020–2024 5-year estimates, place-level tables B25018 (median rooms), B25035 (median year built), B25077 (median home value), B25024 (units in structure), B25003 (owner and renter occupancy) and B25041 (bedrooms) (https://data.census.gov/)
- NumeralQ pricing model v2: typical-job midpoints for all 147 markets, compared with the Census median home value (methodology at /methodology)
- Levelset, Iowa lien law FAQs (statute sections as cited there), checked November 10, 2026 (https://www.levelset.com/mechanics-lien/iowa-lien-law-faqs/)
Installed: Gas furnace, 95-96% AFUE