Deck & Patio Cost in San Francisco, CA: 2026 Local Guide

Typical San Francisco job · 320 sq ft
$6,740-$9,24025% above U.S.

In San Francisco, a 320 sq ft deck or patio usually costs $6,740-$9,240, 25% above the national typical job.

The median home in San Francisco was built in 1946, and older yards may need an old deck torn out and footings redone.

For comparable written proposals, confirm dimensions and elevation, footing and attachment details, decking and guard scope, and grading or drainage work.

Your options

Budget
Patio: plain concrete
$3,000-$3,970
Most common
Deck: pressure-treated wood
$6,740-$9,240
Premium
Deck: ipe hardwood
$15,010-$21,240
  • Local labor and material prices
  • 147 U.S. markets
  • Free, no sign-up to see your range
Cost by size

Deck or patio cost by size

Find your size in the table. In San Francisco the range runs from $2,110-$2,890 for 10 x 10 ft to $12,630-$17,330 for 20 x 30 ft; a quote that does not state the measured size is hard to compare.

SizeCost
10 x 10 ft$2,110-$2,890
12 x 12 ft$3,030-$4,160
12 x 16 ft$4,040-$5,550
16 x 16 ft$5,390-$7,400
16 x 20 ftMost common$6,740-$9,240
20 x 20 ft$8,420-$11,560
20 x 30 ft$12,630-$17,330

Installed: Deck: pressure-treated wood

Cost by material

Deck or patio cost by material or type

The gap between options is wide: deck: ipe hardwood costs about 2.3 times as much as deck: pressure-treated wood in San Francisco, and patio: plain concrete trims about 56%.

TypeTypical jobInstalled
Patio: plain concrete$3,000-$3,970$9.38-$12.42 installed
Patio: gravel$3,170-$4,410$9.91-$13.77 installed
Patio: brick pavers$4,920-$6,740$15.38-$21.07 installed
Patio: flagstone$5,110-$12,500$15.97-$39.08 installed
Patio: stamped concrete$5,440-$7,230$17.01-$22.58 installed
Patio: concrete pavers$5,640-$7,710$17.62-$24.10 installed
Deck: pressure-treated woodMost common$6,740-$9,240$21.05-$28.89 installed
Patio: slate$6,790-$10,520$21.20-$32.88 installed
Show 9 more options
TypeTypical jobInstalled
Patio: porcelain pavers$7,080-$10,630$22.14-$33.21 installed
Patio: travertine pavers$7,170-$9,570$22.41-$29.90 installed
Patio: bluestone$7,780-$12,100$24.33-$37.82 installed
Deck: cedar$7,890-$11,310$24.66-$35.34 installed
Deck: redwood$10,770-$14,690$33.67-$45.92 installed
Deck: aluminum$11,320-$14,950$35.37-$46.72 installed
Deck: composite$12,220-$17,450$38.20-$54.53 installed
Deck: PVC$13,340-$17,630$41.69-$55.08 installed
Deck: ipe hardwood$15,010-$21,240$46.90-$66.38 installed

Materials include waste and contractor markup. Typical job: 320 sq ft

What will your San Francisco deck or patio cost?

We have already loaded San Francisco prices for this deck or patio estimate. Enter your project details and ZIP code for a free planning estimate.

Get my estimate
Project extras

Add-ons and extra work

These 8 extras are where quotes most often grow. The largest single line in San Francisco is "Pergola or cover structure" at $5,730-$9,800 for the job, so ask whether it is included.

  • Railing: wood$44.75-$60.59 / linear ft
  • Railing: aluminum or steel$59.31-$98.23 / linear ft
  • Railing: composite$109-$184 / linear ft
  • Railing: cable$123-$201 / linear ft
  • Railing: glass$151-$251 / linear ft
  • Stairs (per step, wood, pre-cut stringers)$145-$235 / step
  • Footing (poured concrete)$277-$458 / each
  • Pergola or cover structure$5,730-$9,800 / job
Show material-only prices
Add-onMaterials
Railing: wood$12.07-$18.11 / linear ft
Railing: aluminum or steel$30.19-$60.38 / linear ft
Railing: composite$60-$121 / linear ft
Railing: cable$85-$151 / linear ft
Railing: glass$97-$181 / linear ft
Stairs (per step, wood, pre-cut stringers)$33.81-$90.56 / step
Footing (poured concrete)$57-$173 / each
Pergola or cover structure$1,720-$4,600 / job

Installed price per unit

Local conditions

What makes San Francisco different for this job

San Francisco homes and the local housing stock

San Francisco homes and outdoor projects

With 70% of units in multi-unit buildings, a deck in San Francisco often needs association approval, and HOA rules can set materials and colors.

Measured against the $1,394,500 median home value, a typical deck or patio in San Francisco is about 0.6% of the house, the 2nd lowest share of the 147 markets on this site.

Local planning note for San Francisco

San Francisco, San Jose and Sacramento side by side

Against home values, a deck or patio costs San Francisco and San Jose owners the same share, 0.6% of the median home, while Sacramento is at 1.4%.

Comparing San Francisco with its neighbors, BLS puts carpenters' median pay 47% above the U.S. median in San Francisco but 23% above the U.S. median in Sacramento, a gap that tends to show up in deck or patio quotes.

San Francisco has the highest permit fee of the three for a deck or patio: $1,056 for the standard job, against $557 in Sacramento.

CityTypical job (midpoint)Share of median home valuePay for carpenters vs U.S.Permit for a $15,000 remodel
San Francisco$7,9900.6%+47%$1,056
San Jose$7,4900.6%+32%Not published
Sacramento$7,1701.4%+23%$557

Typical job: midpoint of NumeralQ's typical-job range for each city. Pay: BLS May 2025 median for the trade vs the U.S. median. Permit: base fee from each city's schedule, before surcharges.

San Francisco Deck & Patio Pricing — 2026 Local Market

Deck or patio cost in San Francisco, CA: $6,740-$9,240 (typical job: 320 sq ft).

San Francisco's ground and weather for decks

San Francisco averages 0 nights a year at or below freezing, according to NOAA's 1991–2020 normals, against 18 at the median California station and 124 at the median U.S. station.

Ask the building department for San Francisco's frost depth. The model code requires deck footings to sit below it, and at least 12 inches down.

The model code exempts only small, low, freestanding decks (under 200 sq ft, under 30 inches high, not attached) from a permit; an attached deck needs one in most places.

Yearly precipitation runs about 19.6 inches here, against 37.5 at the median U.S. station.

Decks in San Francisco at a glance
Nights at or below 32°F0
Yearly precipitation19.6 in
Climate zone (county)3C
Contractor license (California)CSLB license unless under $1,000, no permit and no employees
Where to check a licenseCalifornia Contractors State License Board

Local data checked October 2026 · Sources at the bottom of the page

Deck permits and Planning review in San Francisco

In San Francisco, the Planning Department's deck handout says decks under 30 inches above natural grade need no building permit, decks over 30 inches need a building permit, and decks over 3 feet also need Planning review. Decks on posts taller than 10 feet, decks in the required rear yard, or decks needing a firewall over 10 feet require 30-day neighborhood notice.

Decks on posts under 10 feet within the buildable area can usually be approved over the counter, and the Planning Code governs over this handout.

SF Planning: Public Information Handout, Residential Decks · Handout updated November 2022; checked October 11, 2026

Nearby pricing

How San Francisco compares with nearby cities

Labor

Labor rates

For deck or patio in San Francisco, contractors bill about $86-$112 per worker-hour for carpenters, whose median pay is $42.89 an hour. The difference covers insurance, taxes, overhead and profit.

Carpenters

$42.89/hrMedian pay
$86-$112/hrBilled rate

Cement Masons and Concrete Finishers

$36.53/hrMedian pay
$73-$95/hrBilled rate

Median pay: BLS May 2025. Billed rate: what a contractor charges per worker-hour, estimated at 2.0 to 2.6 times pay (insurance, payroll taxes, overhead, profit).

Before you sign

Before you sign in San Francisco

Get every quote to include

  • measured dimensions, height, stairs, and guard or rail scope
  • footings, attachment details, and framing materials
  • decking or patio surface, demolition, and disposal
  • grading, drainage, access, and site restoration
Common questions

Frequently Asked Questions

How much does Deck & Patio cost in San Francisco, CA?

Deck or patio cost in San Francisco, CA: $6,740-$9,240 (typical job: 320 sq ft). Each option in the price table above has its own range.

How does pay for carpenters in the San Francisco-Oakland-Fremont area compare with the national median?

Median pay for carpenters in the San Francisco-Oakland-Fremont, CA metro area is 47% above the national median, according to BLS data for May 2025. Pay is one input to a quote, not the price itself.

How often does damaging wind hit San Francisco County?

NOAA logged 1 thunderstorm wind reports of 58 mph or more in San Francisco County from 2016 to 2025.

Ready for your own number?

We have already loaded San Francisco prices for this deck or patio estimate. Enter your project details and ZIP code for a free planning estimate.

Get my estimate
Illustrative payment estimates NumeralQ examples use fixed assumptions. They are not loan offers or pre-qualification; NumeralQ does not contact lenders or access credit reports. View payment assumptions

Sources and methodology

  • NumeralQ estimator (pricing as of 2026-10-26)
  • Fixr cost guide, retrieved 2026-10-26
  • Home Depot online prices, store 121, retrieved 2026-10-26
  • NumeralQ estimate (no single published range; set from material prices and typical install hours)
  • Ready-mix delivered price, 2026 trade reporting ($130-$175/cu yd)
  • U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025 (https://www.bls.gov/oes/)
  • City permit fee schedules, retrieved October 2026 (see the permit line for this page's source)
  • NumeralQ pricing model v2: materials plus local labor, methodology at /methodology
  • https://media.api.sf.gov/documents/Table_1A-A_-_Building_Permit_Fees_2026.pdf
  • U.S. Census Bureau, American Community Survey 2020–2024 5-year estimates, place-level tables B25018 (median rooms), B25035 (median year built), B25077 (median home value), B25024 (units in structure), B25003 (owner and renter occupancy) and B25041 (bedrooms) (https://data.census.gov/)
  • NumeralQ pricing model v2: typical-job midpoints for all 147 markets, compared with the Census median home value (methodology at /methodology)
  • U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics, May 2025, metro-area median pay by trade compared with the U.S. median (https://www.bls.gov/oes/tables.htm)
  • NumeralQ comparison of city base permit fees for standard jobs ($15,000 re-roof, $12,000 HVAC replacement, 150 ft fence), read from each city's fee schedule on 26 Oct 2026

NumeralQ planning estimate. How we estimate

$6,740-$9,240NumeralQ planning estimate
Get my estimate