What the storm record shows for Montgomery roof repairs
From 2016 to 2025, Montgomery County and the 7 counties around it had 325 NOAA reports of thunderstorm wind at 58 mph or more and 48 reports of hail 1 inch or larger.
Per 1,000 square miles that is 62.2 wind reports, against 107.2 across Alabama and 48.8 nationally.
Wind damage usually shows up as lifted or missing shingles, torn flashing or missing ridge caps; hail damage as bruised shingles and lost granules. Ask the roofer to note which they find.
Storm record for Montgomery County roofs| Damaging wind (58 mph+) in Montgomery County, 2016–2025 | 36 reports |
|---|
| Large hail (1 in+) in Montgomery County | 9 reports |
|---|
| FEMA strong-wind rating (county) | Relatively High |
|---|
| Months with the fewest reports (area) | Sep, Oct, Nov |
|---|
| Roofer license (Alabama) | Roofer license for residential roofing over $2,500 |
|---|
| Where to check a license | Alabama Home Builders Licensure Board |
|---|
Local data checked October 2026 · Sources at the bottom of the page
Montgomery homes and the local housing stock
How old Montgomery roofs are likely to be
Who signs the contract matters for roof repairs: in Montgomery, 73% of units are single-family houses and 54% of homes are lived in by their owners. Montgomery roof repairs happen in homes about the same age as those in the other Alabama cities NumeralQ covers: half were built in 1978 or earlier, against 1975 there.
With half of Montgomery's homes 48 years old or more, repairs often land on aging roofs. Ask the roofer whether patching makes sense against InterNACHI's 20- to 30-year shingle life.
Montgomery Floodplain Standards
City rule
In Montgomery special flood hazard areas, new construction and substantial improvements require the lowest floor, including basements, to be elevated at least 2 feet above the base flood elevation. Substantial improvement is measured per project, while cumulative damage is tracked over a 10-year period.
Applies to special flood hazard areas.
Montgomery Code Secs. 5-605 Definitions and 5-652 Specific technical standards · Checked October 10, 2026
Permits in Montgomery
A like-for-like roof replacement, such as asphalt shingles for asphalt shingles, doesn't need a permit in Montgomery, according to the city's Inspection Department. Changing the roofing material or the slope, or altering the roof's supports or bracing, is different: the city then requires plan review and a structural engineer's approval.
Montgomery Roofing Standards
City rule
Montgomery requires a drip edge at eaves and rake edges of shingle roofs, with segments overlapped at least 2 inches, extending at least 1/4 inch below roof sheathing and 2 inches onto the deck. Fasteners must be spaced at most 12 inches on center. An exception is provided if a 1x2 shingle mold is attached to the fascia and the starter course extends between 1/4 inch and 1-1/4 inches.
Applies when the eave or rake edge is part of the roofing work.
Sec. 5-71 Adoption of the technical codes: IRC R905.2.8.5 amendment · Checked October 10, 2026